Lead solder paste syringe - Sn63Pb37 / Sn62.9Pb36.9Ag0.2 alloy composition: Sn63Pb37 / Sn62.9Pb36.9Ag0.2 product melting point: 183 particle size: 10-15μm / 20-45μm store Description: Lead tin syringes 30g and 100g cream using a syringe fitted, special weight to customer requirements can be stored at 2-10 ℃ environment for a period of six months, to be the next time the temperature above room temperature for 2-4 hours before open before use to prevent moisture produce tin beads. Scope: all environmental requirements without dispensing technology electronic products. Lead solder paste syringe barrel characteristics lead solder paste, solder ball, and Japan by imported high-performance active agents, thixotropic agents, development, with excellent weldability and stable printing of this section syringes Paste products have the following characteristics :: 1, excellent welding results, bright spot; 2, excellent performance, no-clean dispensing, fine paste, dispensing uniform, out of the tin and smooth, continuous tin, excellent resistance to collapse performance; 3, can well suppress the generation of solder balls, solder wettability is good, full of bright spot less residue after soldering, light color, non-corrosive, high insulation resistance; 4, designed for dispensing components welding process design, Fine needle has good applicability, in eight hours of use are available dispensing performance. Lead solder paste syringe - safety knowledge have lead solder reflow process will produce steam, should pay attention to the job of air ventilation to avoid inhalation. Technical support: Shenzhen gifted Ritter Technology Co. www.u-tel520.com mobile phone 18938680221 Xiao Lizhi